RF24Audio  v1.0
Arduino Audio Streaming Realtime with NRF24L01 radios
 All Classes Files Functions Pages
RF24Audio - Realtime Audio Streaming Library for Arduino

This class implements a realtime audio streaming solution using nRF24L01(+) radios driven by the newly optimized RF24 library fork.

Features

How to learn more

Configuration and Setup

The settings for the library will generally be detected automatically. To change from the default pin assignments etc, edit the userConfig.h file. The mandatory user options in the configuration file are shown below:

#define SAMPLE_RATE 24000 //The sample rate to use for transferring audio samples Note: 44khz+ sample rate requires 8-bits per sample
#define RF_SPEED RF24_1MBPS //RF24_250KBPS will do 13-20khz+ sample rate, RF24_1MBPS up to 24-44khz+, RF24_2MBPS for higher. These are not limits, just a guide.
#define ANALOG_PIN A0 //The pin that analog readings will be taken from (microphone pin)

Pin Assignments: See the Setup.html page for wiring diagrams

See http://arduino.cc/en/Tutorial/InputPullupSerial for info on how to wire the buttons to the pins See userConfig.h to change default pin assignments and options.

Advanced Usage

The radio pipes are defined as follows. For more complex multicast scenarios, radios can listen on any combination of pipes.
Use the getAddress(); function to access the address array.

const uint64_t pipes[14] = { 0xABCDABCD71LL, 0x544d52687CLL, 0x544d526832LL, 0x544d52683CLL,0x544d526846LL, 0x544d526850LL,0x544d52685ALL, 0x544d526820LL, 0x544d52686ELL, 0x544d52684BLL, 0x544d526841LL, 0x544d526855LL,0x544d52685FLL,0x544d526869LL};

By default, all radios will open the same reading & writing pipes on the first two addresses.
Any radio that wishes to transmit, will reverse the addresses on the first two pipes, and begin to transmit to all the other nodes.
Every radio will automatically be assigned the first two addresses, then one of the remaining addresses as a private channel, based on its radio number:
(0 = pipes[2], 1 = pipes[3])

Additional addresses can be added by modifying the address array listed in userConfig.h