examples/RF24Network/helloworld_rxEncryption/helloworld_rxEncryption.ino

 
#include <nrf_to_nrf.h>
#include <RF24Network.h>
 
//Set up our encryption key
uint8_t myKey[16] = {1,2,3,4,5,6,7,8,9,0,1,2,3,4,5,6};
 
nrf_to_nrf radio;  // nRF24L01(+) radio attached using Getting Started board
 
RF52Network network(radio);      // Network uses that radio
const uint16_t this_node = 00;   // Address of our node in Octal format (04, 031, etc)
const uint16_t other_node = 01;  // Address of the other node in Octal format
 
struct payload_t {  // Structure of our payload
  unsigned long ms;
  unsigned long counter;
};
 
 
void setup(void) {
  Serial.begin(115200);
  while (!Serial) {
    // some boards need this because of native USB capability
  }
  Serial.println(F("RF24Network/examples/helloworld_rx/"));
 
  if (!radio.begin()) {
    Serial.println(F("Radio hardware not responding!"));
    while (1) {
      // hold in infinite loop
    }
  }
 
  radio.setKey(myKey);           // Set our key and IV
  radio.enableEncryption = true; // Enable encryption
  radio.enableDynamicPayloads(123); //This is important to call so the encryption overhead will not be included in the 32-byte limit
                                    //To overcome the 32-byte limit, edit RF24Network.h and set MAX_FRAME_SIZE to 111
  radio.setChannel(90);
  network.begin(/*node address*/ this_node);
}
 
void loop(void) {
 
  network.update();  // Check the network regularly
 
  while (network.available()) {  // Is there anything ready for us?
 
    RF24NetworkHeader header;  // If so, grab it and print it out
    payload_t payload;
    network.read(header, &payload, sizeof(payload));
    Serial.print(F("Received packet: counter="));
    Serial.print(payload.counter);
    Serial.print(F(", origin timestamp="));
    Serial.println(payload.ms);
  }
}